ESR metar LCR-T4 multifunkcijski tester 

? Isprobajte revolucionarni LCR-T4 grafički višenamjenski tester! ?

✨ Mali, ali moćan! ✨ Ovaj tester ima sve što vam treba za brzu i preciznu provjeru komponenti na vašoj PCB pločici. Bez obzira jeste li profesionalni inženjer, entuzijastični hobist ili student, ovaj tester će vam olakšati život!

? Dimenzije i težina ? Sa kompaktnim PCB veličine 63x71 mm i težinom od samo 48g, ovaj tester je izuzetno lagan i praktičan za nošenje sa sobom.

? Višenamjenski funkcionalnosti ? LCR-T4 tester vam omogućava brzu i jednostavnu provjeru raznih komponenti na vašoj pločici, uključujući:
- Otpornike
- Kondenzatore
- Diode
- Tiristori
- Induktore
- Tranzistore
- MOSFET-ove

? Prikaz informacija ? Sa LCD 12864 ekranom i pozadinskim osvjetljenjem u žuto-zelenoj boji, jasno ćete vidjeti rezultate testiranja.

? Napajanje ? Tester se napaja preko 9V baterije, a za dugotrajno napajanje možete koristiti 2 litijumske baterije za ukupno 8,4V snage.

⚙️ Jednostavan za korištenje ⚙️ Sa automatskim prepoznavanjem NPN i PNP tranzistora, N-kanalnih i P-kanalnih MOSFET-ova, dioda, tiristora, otpornika, kondenzatora i drugih komponenti, testiranje je brzo i jednostavno.

? Brzi testovi ? Uz impresivnu brzinu testiranja, većina komponenti će biti provjerena u samo 2 sekunde. Samo za velike kondenzatore testiranje može potrajati nešto duže, ali i dalje će biti gotovo za manje od 1 minute!

? Dodatne karakteristike ? Tester dolazi sa mnogim dodatnim značajkama, uključujući:
- Detekciju naponskog ishodišta tranzistora
- Mjerenje praga napona i kapaciteta vrata MOSFET-a
- Automatsko gašenje za economično korištenje baterije i produljenje vijeka trajanja.

⚙️ Jednostavan za korištenje ⚙️ Sa automatskim prepoznavanjem NPN i PNP tranzistora, N-kanalnih i P-kanalnih MOSFET-ova, dioda, tiristora, otpornika, kondenzatora i drugih komponenti, testiranje je brzo i jednostavno.



• 128*64 big Backlight LCD display, only 2mA when stand by.
• Inductors, capacitors , diodes, dual diode , mos, transistor, SCR , the regulator, LED tube , ESR,
• Resistance, Adjustable potentiometer
• Resistance : 0.1 ohm resolution, maximum 50M ohm
• Capacitor : 25pf -100,000 uf
• Inductors : 0.01mh-20H
• Automatic detection of NPN and PNP transistors, n-channel and p-channel MOSFET,
diode (including double diode), thyristor, transistor, resistor and capacitor and other components
• Automatic test the pin of a component, and display on the LCD

• Can detect the transistor, MOSFET protection diode amplification coefficient
and the base to determine the emitter transistor forward biased voltage
• Measure the gate and gate capacitance of the MOSFET threshold voltage
• Use 12864 liquid crystal display with green backlight

1. One click operation, automatically turning off the power.
2. The shutdown current is only 20nA and supports battery operation.
3. Automatic detection of PNP and NPN bipolar transistors, N, P channel MOSFETs, JFETs, diodes, dual diodes, thyristor thyristors.
4. Automatically detect pin layout.
5. Measure the current amplification coefficient and threshold voltage of the emission junction of a bipolar transistor.
6. Darlington transistors can be identified by high threshold voltage and high current amplification coefficient.
7. Detection of protective diodes for bipolar transistors and MOSFETs.
8. Measure the threshold voltage and gate capacitance value of MOSFETs.
9. Supports the measurement and symbol display of two resistors, with up to four digits and units displayed. The displayed resistance symbol shows the connected tester probe numbers (1-3) at both ends. So Potentiometer can also measure. If the Potentiometer is adjusted to one end of it, the tester cannot distinguish between the pins in the middle and at both ends.
10. The resolution of resistance measurement is 0.1 ohms, with a maximum measurement value of 50M ohms.
11. A capacitor can be detected and measured. Display the highest four digits and units. The value can range from 25pf to 100mF. Resolution up to 1 pF
12. It is possible to measure the Equivalent series resistance (ESR) capacitance of capacitors with a value above 10UF. The resolution is 0.01 ohms and displays two digit values.
13. It is possible to display symbols in the correct direction for two diodes. In addition, the positive voltage drop is displayed.
14. The LED is detected as a diode, and the forward voltage drop is much higher than Normal height. Double light-emitting diodes are detected as double diodes.
15. Zener diodes can be detected if the reverse breakdown voltage is below 4.5V. This will be displayed as two diodes, which can only be determined by voltage. The symbols around the diode of the probe are the same, in this case, you can identify the true anode of the diode by the threshold voltage near 700mV!