Dynacord Sub 112

 
DYNACORD´ s SUB 112 is a vented, direct radiating cabinet, equipped with the high-power DYNACORD DND12S400 neodymium transducer. The conical vent system shows significantly less distortion and lower air noise at low frequencies than common circular vent openings.   The SUB 112 contains a passive filter, 6 dB/oct. , that suppresses high frequencies. Appropriate fullrange cabinets, e. g. DYNACORD’s D 8 can therefore be directly connected in parallel to the SUB 112 if an extended bass reproduction is required. You just have to connect the SUB 112 and the D 8 with a regular Speakon cable in parallel. The SUB 112 cabinet is made of 15mm birch plywood. All corner joints and braces are grooved and glued. The cabinet´ s surface is painted with a 2-K laquer finish . The acoustic foam front on a powder coated steel grille protects the DND12S400 woofer against damage during transport and bad environmental conditions.  

Cabinet Subwoofer
Configuration Built-In Hi-Cut Filter
Nominal impedance 8 Ohms
Rated power RMS 400 Watts Program power 800 Watts Peak power 1600 Watts
SPL 2,83 V / 1m 1 W / 8 Ohm 92 dB
Max. SPL 1m (calculated with peak power) 124 dB
Frequency range ( -10dB ) 43Hz - 350Hz
Passive crossover frequency 124 Hz
Component SUB DND12S400 Order No. D366712
Connectors SUB 1+, 1- Wired through 2+, 2-
Connector model Speakon NL4MPR
Dimensions (WxHxD) mm 445 x 380 x 445 mm
Shipping weight 22 kg
Net weight 20 kg