************* Trenutno nema ************
DC/DC konvertor koji moze da meri napon i struju sa kucistem od pleksiglasa.
Odlicnan kao mali laboratorisjki ispravljac kome moze da se menja napon i struja, led drajver, punjac baterija. . .
Ulazni napon mora da bude bar 2V visi od izlaznog.
Na poledjini ima mesto za montazu malog ventilatora ukoliko ima potrebe, na jednoj slici je primer montaze.
Description
Output voltage: 1.5-32V(5A) continuously adjustable, automatically save last set voltage(input voltage must be higher more 1V than output voltage).
Output current: maximum 5A(recommended for use in 4.5A), When heating is large, please solve heat dissipation problem on your own.
The module has calibration function, do not worry that if the measurement is not accurate.
Compact and portable step-down power supply module, easy to carry and use.
Conversion efficiency is up to 95%, and precision is 1%. Specification:
Color: show as pictures.
Size: 65.6x40x25mm(5A).
Material: metal, electronic components.
Input voltage: 6V-32V(5A)
Output voltage: 1.5-32V(5A) continuously adjustable, automatically save last set voltage (input voltage must be higher more 1V than output voltage).
Output current: maximum 5A(recommended for use in 4.5A)When heating is large, please solve heat dissipation problem on your own. (Note: the current is adaptive based on load, and it is not adjustable).
Input defense counter: yes.
Short circuit protection: 5A is supported.
Precision: 1%, three bit display, current unit is A.
Conversion efficiency: up to 95% (efficiency is related to input, output voltage, current and differential pressure).
The load adjustment rate: S(I)≤0.8%, and the voltage regulation rate: S(u)≤0.8%. Note
If it is used for charging, after charging is completed, please disconnect the battery terminal firstly, and disconnect the input terminal, to prevent the battery from returning to the damaged module.
Calibration method : Power voltage calibration: cases, hold down the "set" button, with electricity, into voltage calibration mode, press the "set" key to add, "ok" to reduce, the calibration for the correct input voltage, power cuts out the calibration completed after 2 seconds!
The F-0 : output voltage
The F-1: inout voltage
The F-2 : alternate display input/output voltage
The USB : USB output voltage