ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt
1 od 8

ESP32-S3 sa 5 inča ekranom, 32-Bit LX7 Dual-Core, WiFi & Bt

4.690 dinFiksno

Odgovara na 100% poruka, uglavnom u roku od 15 minuta.
MALINA 314 DOO online
Beograd
Član od 17.05.2019.
kp izlog
Novo
19
0
pre 5 dana
Dostava
Lično preuzimanje

SKU: 30320
Part No. : ESP32-S3-LCD-5B,  no touch, 1024×600
Brand: Waveshare

 

Korisne informacije: www. waveshare. com/wiki/ESP32-S3-Touch-LCD-5

  ESP32-S3 5inch Display Development Board, 32-Bit LX7 Dual-Core Processor, Up To 240MHz Frequency, Supports WiFi &Bluetooth, With Onboard Antenna, 1024×600, no touch   ESP32-S3 5″ LCD Development Board  

Integrates RGB interface LCD

Features  

This product is a microcontroller development board with 2.4GHz WiFi and BLE 5 support, integrates high-capacity Flash and PSRAM. Onboard 5inch LCD screen can smoothly run GUI programs such as LVGL. Combined with various peripheral interfaces, suitable for the quick development of the HMI and other ESP32-S3 applications

  • Equipped with Xtensa 32-bit LX7 dual-core processor, up to 240MHz main frequency
  • Supports 2.4GHz Wi-Fi (802.11 b/g/n) and Bluetooth 5 (LE), with onboard antenna
  • Built in 512KB SRAM and 384KB ROM, with onboard 16MB Flash and 8MB PSRAM
  • Onboard 5inch LCD display, 1024×600 resolution, 65K color
  • Supports capacitive touch control via I2C interface, 5-point touch with interrupt support (for touch version only)
  • Onboard voltage regulator, supports 7~36V wide range power supply
  • Onboard RTC chip and rechargeable battery to ensure time data is not lost when power loss
  • Onboard CAN, RS485, I2C interface, TF card slot, MX1.25 2P battery header, and digital isolated IO interfaces, etc.
  • Supports passive and active digital input, with bi-directional optocoupler isolation
  • Supports digital output with optocoupler isolation, provides higher driving capability with up to 450mA sinking current
  • Onboard LED indicators for indicating the power and battery recharging status
  • Supports flexible clock, module power supply independent setting and other controls to realize low power consumption in different
IPS Display Panel  

Excellent display performance, 178° wide viewing angle *

 

Supports multiple peripherals  

Supports the expansion of multiple peripherals via CAN, RS485, I2C and isolated IO interfaces

 

What’s On Board

 
  1. ESP32-S3-WROOM-1-N16R8
    The SoC with WiFi and Bluetooth, up to 240MHz operating frequency, integrated 8MB PSRAM and 16MB Flash
  2. TF card slot
  3. USB Type-C port
  4. BOOT button
    Press and hold while powering on for program burning
  5. RESET button
  6. Optocoupler isolation
  7. Touch panel connector
  8. 5inch display panel connector
  9. RS485 and CAN terminal resistors selection
    close by default
  10. Battery power supply ON/OFF
  11. 3.7V single lithium battery GH1.25 header
  12. Status Indicators
    DONE: Lithium battery charging completed indicator
    CHG: Lithium battery charging indicator
    PWR: Power supply indicator
    (the CHG will blink and DONE will light on when connecting with DC power supply and without lithium battery connected or battery switch is OFF)
  1. 7-36V DC power supply terminal
  2. I2C interface terminal
    VOUT pin output 5V/3.3V (switching by onboard resistor)
  3. CAN interface terminal
  4. RS485 interface terminal
  5. Digital output
    5~36V, open-drain output, output load: 450mA per channel (MAX)
  6. Input signal common terminal
    NC: dry contact passive input
    Connect to power supply positive: digital input low active, for NPN wet contact active input, 5V-36V DC
    Connect to power supply negative: digital input high active, for PNP dry contact active input, 5V-36V DC
  7. Digital input
    5~36V, supports passive / active input (NPN or PNP)
  8. I2C VOUT output selection
    for switching output valtage and I/O level of I2C VOUT, 3.3V by default
  1. CS8501
    Lithium battery recharge manager
  2. PCF85063
    RTC chip for providing accurate time control
  3. AP3032KTR-G1
    Display backlight boost converter
  4. CH422G
    IO expansion chip
  1. SP3485
    RS485 transceiver
  2. TJA1051T/3/1J
    CAN transceiver
  3. SGM2212-3.3
    800mA low-noise LDO
  4. Rechargeable Lithium battery
Package content:   Weight:  0.144 kg ESP32-S3-LCD-5

OPTIONS ESP32-S3-LCD-5 (with bottom wiring 16PIN screw terminal) x1

 

w30320

ꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥ

  Račun.
  Garancija.
  Zagarantovana sva prava kupaca po osnovu zakona o zaštiti potrošača.
  

  Malina314 doo

ꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥꕥ

 

Slanje sa kurirskim službama.

Plaćanje pre slanja ili pouzećem.

Malina314 doo
Pogledajte i naše druge oglase.

Volimo da prodajemo.

ID Oglasa: #179351745
Informacije

Na našem sajtu proverite stanje zaliha ili ovde porukom.

Na našem sajtu svakog meseca atraktivni popusti.  
Platite karticom ili IPS QR kodom na našem sajtu.

Veliki izbor displeja (1-15"), LCD, E-ink.
RPi ploče, kućišta, kablovi, kamere, memorijske kartice, dodatna oprema.   
Za fizička lica i firme.

Slanje sa BEX
Povoljne cene poštarine već od 300-350 din.

U skladu sa Pravilima i uslovima korišćenja i Polisom o poštovanju privatnosti, KupujemProdajem koristi Cookie-je da bi obezbedio dobro korisničko iskustvo, prikazivanje personalizovanog sadržaja, prikazivanje reklama, kao i druge funkcionalnosti i usluge koje ne bismo mogli da obezbedimo bez Cookie-ja.

PredlogProblemKontakt