NOVO u ponudi MIKROMETAR ZA RUPE od 5 do 30mm
--------------------------------------------------------------------
prikaz 0,01mm
tacnost 0,005mm
materijal INOX
mikrometar je nov i nekoriscen, pozovite za vise informacija
saljem post ekspresom danas do sutra
Nuliranje:
- Clean the surface of measuring anvil heads with a soft cloth, then rotate measuring device to make two measuring surface contact. If two zero lines of differential sleeve and fixed barrel do not alignment, use the following two methods to adjust.
- Method 1:If the error is less than 0.02mm (0.001"), use ratchet stop to lock screw tightly, then use wrench to pull fixed barrel till two zero lines alignment.
- Method 2:If the error is greater than 0.02mm (0.001").
Step1, use ratchet stop to lock screw tightly, then use wrench to loosen the ratchet stop and remove differential sleeve.
Step2, re-align zero lines of fixed barrel and differential sleeve, then put ratchet stop back on. If necessary, adjust it again using method 1.
U skladu sa Pravilima i uslovima korišćenja i Polisom o poštovanju privatnosti, KupujemProdajem koristi Cookie-je da bi obezbedio dobro korisničko iskustvo, prikazivanje personalizovanog sadržaja, prikazivanje reklama, kao i druge funkcionalnosti i usluge koje ne bismo mogli da obezbedimo bez Cookie-ja.