> Tajmer, naponska zastita i kombinovano <

Multifinkcionalni modul koji moze da radi kao tajmer oican i ciklicni, zastita akumulatora. . .

This product is designed to meet the relevant national standards and electrical safety rules , with industrial-grade reliability, Selection of original authentic chips and components, Acer licensing power relays, military grade PCB, SMT chip technology, Is highly cost-effective , high-quality multifunction models relay control panel that allows you to control the lowest cost to meet a variety of needs.

Please follow the instructions wiring and operation ! This board is 12V power supply operating power range DC 10-15V, then 5.08mm connector terminals , as shown below .

The relay load contacts with three contacts ( a conversion ) : common point , normally closed , normally open , when the relay is not energized , the relay is released , the common point and normally closed switched on , when the relay coil is energized relay picks , common and normally open points will be connected .

Relay contact is equivalent to the switch, the wiring should be in series with the load power supply circuit , Power must not be short-circuited , contact a maximum load current of 10A.

Multiple modes for users to freely switch , a multifunction machine , premium application !

Mode display :

P-1: Time Relay (0.1 seconds to 99.9 seconds )

P-2: Time Relay ( 1 second to 999 seconds, 1 minute to 999 minutes )

P-3: Counting relay ( set value can count to start the relay, opto-isolated inputs )

P-4: Voltage Relay ( can be set lower limits on the voltage , overload relay )

P-5: switch timing trigger ( when the input level switch or timer to set the value of the trigger )

P-6: digital display automatically turns off the set ( minimum operating current 6mA / 12V)

 

Voltage detection and display range : Default DC 0-99.9V ( precision 0.1V) or DC 0-9.99V ( precision 0.01V), two hardware versions ;

If the power failure in either mode operation, the power again after the last state of the system will continue to run , parameter setting can be powered down to save , in either mode, press the ENTER key three seconds to return to the mode selected.

 

Electrical PropertiesParameters:

• Working Power supply : DC10 ~ 15V
• A set of conversion ( normally open normally closed )
• Contact load : 10A / 277VAC  10A / 30V DC
• Contact resistance : 100mΩ  (1A-6VDC)
• Mechanical Durability: > 10 million times
• Electrical Durability: > 100,000 times (10A-250VAC)
• Working temperature : -40℃ ~ 85℃
• Standby Current: 16mA / 12V Minimum , the digital closed 6mA / 12V And relay timely 45mA / 12V
• External signal input : voltage (5 ~ 12V); passive switch ( can be set to nine to shake delay time )
• External signal or switch can trigger start relay
• You can set the time T1 pull and release time T2, can also be a single execution cycle execution , set value can be powered down to save
• Mode setting parameters can be powered down to save on electric mode execution continues after the last power failure
• Digital control module uses the socket , the display can be turned off automatically.