> Digitalni termostat 220V od -55 do 120C <

Digitalni termostat , termoregulator u kucistu.
Zbog velikog histerezisa cesto se koristi za pumpe centralnog grejanja i slicne namene.

Opseg regulisanja temperature: -19 do 99C
Greska merenja: 0.3C
Rezolucija: 0.1C
Senzor Model: NTC (10K/B3435)
Tacnost regulacije: 1C
Napon napajanja: AC 220V
Struja kontakta relea: 10A.
Radna temperatura: 0~50
Dimenzije:  81x55x31mm

Moze da radi u rezimu hladjenja i grejanja, na levom displeju se zada jedna temperatura, na desnom druga a centralni prilazuje trenutnu.

Usage method:

1. Plug the plug of this product to a household socket. If the screen displays temperature, it means the power supply has been correctly connected.

2. Put the temperature control probe into the places that need temperature control, and set the start and stop temperature according to your needs.

3. Plug the plugs of heating and refrigeration devices to the socket of temperature controller, and then you can achieve temperature control.


Operation instructions:

After power-on, if the temperature is within the range, you should immediately start the output and make it stop when it reaches the set value.
 
Start temperature For example, if you want to control water boiling to stop at 60 Celsius degrees and start over at 45 Celsius degrees, then you should set the start value as 45 and stop value as 60.

Start temperature > stop temperature: refrigeration mode

For example, in summer, you want to control the greenhouse to start the scavenger fan when the temperature is higher than 35 Celsius degrees and stop at 32 Celsius degrees, then you should set the start value as 35 and stop value as 32.

SET: function button/power-on &power-off button

In the state of power-on, you can switch off by a long press for 3 seconds. After switched off, it will still remain power-off if there is no power supply.

In the state of power-off, you can switch on by pressing SET once. After switched on, it will still remain power-on if there is no power supply.

In the state of normal temperature control, you can switch between F-1~F-3 by pressing SET once.

F-1 intermittent work mode unit: minute left: start minute right: stop minute

F-2 time switch left: hour right: minute 99h59mins max

F-3 time switch left: hour right: minute 99h59mins max

Temperature correction: Enter the temperature correction function by removing the controller plug and pressing SET to supply power. The screen displays –00--. You can increase or decrease temperature on the basis of the original temperature, maximum range -9.9~+99. After correction:

Real-time temperature = the temperature before correction + the corrected value

Press (start+-) power-on to enter self-check function;

Press (stop+-) power-on to restore factory settings.

Restore factory settings:

If there is some setting mistake or setting disorder, you can press the two stop buttons to restore factory settings.

When the screen displays 88-888-88, and the buzz gives out a long sound, it means the restoration has finished.