Darkglass Microtubes 900 v2

Neverovatna ponuda na našem tržištu!
DarkGlass samo u AudioPro-Artist-u po NAJBOLJIM CENAMA!

Pre tri godine Darkglass Electronics je objavio svoje prvo pojačalo Microtubes 900. Njegove neobične osobine i dizajn su proslavile Darkglass kao ni jedan od prethodnih proizvoda. Bilo je to beskompromisno pojačalo, neverovatno kvalitetno i glasno. Sada, hiljadu dana nakon što su prvi Microtubes 900 izašli iz proizvodnje, ponosni smo što objavljujemo sledeći korak u evoluciji ovog uređaja. Microtubes 900 v2 je sinonim za kvalitet !

Front Panel Features:

Input
Use this jack to connect your instrument via a standard 1” mono cable.

Passive/Active
Use this push-button switch to change from passive to active mode. If your bass is active it can have a hotter signal making the amp to distort early (feel free to use if such additional distortion is desired).

Microtubes
Use this push button to turn on or off the Microtubes Engine to add natural compression, organic harmonic enhancement, and saturation ranging from mild overdrive to high gain bass rage.   The Microtubes Engine operates before the clean section (you can therefore use the 6 Band Active EQ for additional tone shaping in addition to the Tone knob described below).

Compression
This knob controls the amount of dynamic compression added to the Microtubes Engine.   The make up gain is adjusted automatically. The compression can be turn off or assigned using the Darkglass Suite.

Drive
This knob controls the amount of distortion that the Microtubes Engine will deliver. It will change from a soft warm overdrive to a massive modern distortion sound.

Tone
This knob controls the high harmonic content of the Microtubes Engine via a variable low pass filter: crank it up for additional attack and definition or dim it down for a smoother sound, especially handy if already running bright clean EQ setting or cabinets with tweeters

Level
Use this knob to control Microtubes Engine’s output volume.

Blend
Use this knob to mix between the Clean signal and the Distortion signal (Microtubes Engine).

Gain
Use this knob to change the volume of the signal before the Active 6 Band EQ. You can set it low for ensuring the cleanest operation possible or set it higher for more aggressive growl.

Bass
+-12dB at 80Hz. Use this knob to change the low content of the signal.

Mids
+-12dB at 250, 500,1.5K and 3Khz. This graphic eq control the mid content of the signal.   

Treble
+-12dB at 5kHz. Use this knob to change the high content of the signal.

Master
Use this knob to control the overall volume of the amplifier.


Back Panel Features:

Speaker Output
Use this connector to connect the amplifier to your cabinet. This Speakon combo jack allows for either Speakon or 1” speaker cable operation. The outputs are connected in parallel.   

Send
Use this output to send the signal to effects pedals.

Return
Use this input to receive the signal from effects pedals. Master volume control is after this input.

Ground
Lift Use this control to lift the ground of the DI XLR output. If you are experiencing ground noise in your DI signal try changing the setting of this control.

Pre DI Output
Use this output to send a balanced copy of your input signal to recording equipment, mixer etc. The output is latency compensated to match with the Post DI Output.

Post DI Output
The signal for this output is taken after the distortion, EQ and effects loop, and processed through the cabinet simulation engine. The output is latency compensated with the Pre DI Output, and not affected by the master volume.

USB
The USB connector allows you to use the Darkglass Suite to load different cabinet impulses or change different parameters on your amp (midi, compressor, etc)

Aux In
Use this connector to provide to the Headphone output music from your laptop, cellphone, mp3 player, etc.

AC Socket
Use this connector to feed electric power to the amplifier. 100 - 230 VAC, 50Hz-60.  

• Na našoj web stranici kod svakog artikla istaknuta je oznaka da li je artikal na stanju ( „ “ ) - 
  
  
• Trudimo se da sve cene držimo aktuelnim na svakodnevnom nivou, greške su moguće . Cena na K. P je informativnog karaktera , informaciju o ceni proverite u našim radnjama.  
  
  
• Plaćanje u našim maloprodajnim objektima vrši se isključivo u DINARIMA . Cena napisana u evrima je informativnog karaktera.  
  
  
• Ukoliko vidite bilo gde bolju cenu za nov proizvod , kontaktirajte nas i mi ćemo se potruditi da napravimo najbolju ponudu za Vas.

Hvala na razumevanju.

Vaš AudioPro Artist

Kontakt:

● AudioPro ARTIST Sistems d. o. o. ●

BEOGRAD
Bulevar Milutina Milankovića 98-100
Novi Beograd 
tel : 011/ 344-28-74

NOVI SAD
Maksima Gorkog 16
tel: 021/ 300-69-11

NE PRIHVATAMO ZAMENE!