JeffTron Mosfet V2 to stock

Professionally designed mosfet without cabling designed for airsoft electric weapons. The device increases the cadence of the weapon and the endurance of the battery compared to the original cabling in the weapon. Fully integrated device inside the v.2 gearbox instead of the original trigger contacts according to the Tokyo Marui standard. Finished cabling adapted for the battery in the stock with a DeanT connector - there is no need to solder anything.

SPECIFICATIONS:
- Built-in mosfet on switching contacts from SHS
- Easy installation inside the gearbox v.2
- Complete cabling allows quick and easy installation in the weapon, it is long enough for all types of weapons with a battery in the back
- Power conductors with a cross-section of 1.5 mm2 with MPPE insulation, blue conductor with a cross-section of 0.34 mm2 with MPPE insulation
- The length of the wires between the end of the gearbox and the connector is 290mm
- Electronics board covered with varnish, which protects against water penetration into the device
- If you want to use your own wires, choose the variant without cabling
- Designed for springs up to m160 (corresponds to a current of 75A for a single shot or 25A of shooting
dose for a maximum of 30s). For higher loads, select Mosfet II (located outside the gearbox)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- Trigger contacts does not burn
- No quiescent current is being drawn
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position in AUTO mode
- For the correct function of this device, it is necessary to have a functional cut-off, tappet plate, reversing latch, trigger and trigger stop (locked) in the gearbox, ie as in the standard gearbox